McIntosh MC122 Power Amplifier (trade in)
A nice used McIntosh MC122 from c.1999, slimline with 120 watts per channel. Good condition. $950 Cdn or best offer, no sales tax.
https://www.mcintoshlabs.com/legacy-products/amplifiers/MC122
Specifications
Power Output Per Channel: 120 watts into 4 ohm or 80 watts into 8 ohm loads is the minimum sine wave continuous average power output per
channel, both channels operating.
Output Load Impedance: 4 or 8 ohms
Rated Power Band: 20Hz to 20,000Hz
Dynamic Headroom: 1.6dB
Frequency Response: +0, -0.25dB from 20Hz to 20,000Hz +0, -3dB from 10Hz to 100,000Hz
Total Harmonic Distortion: 0.005% maximum at any power level from 250 milliwatts to rated power per channel from 20Hz to 20,000Hz, both
channels operating.
Intermodulation Distortion: 0.005% maximum if instantaneous peak output per channel does not exceed twice the rated output with both channels
operating for any combination of frequencies from 20Hz to 20,000Hz.
Signal To Noise Ratio: 110dB below rated output
Sensitivity: .8 volts (2.5V at the marked position)
Input Impedance: 10,000 ohms
Damping Factor: Greater than 100 at 4 ohms, Greater than 200 at 8 ohms
Power Requirements
100 Volts, 50/60Hz at 3.4 amps
110 Volts, 50/60Hz at 3.1 amps
120 Volts, 50/60Hz at 2.8 amps
220 Volts, 50/60Hz at 1.5 amps
230 Volts, 50/60Hz at 1.5 amps
240 Volts, 50/60Hz at 1.4 amps
NOTE: Refer to the rear panel of the MC122 for the correct voltage
Dimensions: 17-1/2 inches (44.5cm) wide, 3-5/8 inches (9.2cm) high, 17-1/2 inches (44.5cm) deep, including clearance for connectors. Allow 3/4 inches (1.9cm) in front of the mounting
panel for clearance.
Weight: 24 pounds (10.9 Kg) net, 39 pounds (17.7 Kg) in shipping carton
